After yesterday's lessons mistake of the corner being planed to low, I learnt from my mistakes and this lesson went much smoother. I managed to finish hand planing the face and edge of the wood, and then using the Surface Planer, made sure that the face and two edges were perfectly flat and square.
 |
| Above: Surface Planner |
After this it was put through the Thicknesser, to get it to the perfect height of 16mm, ready to be cut into the correct sizes,
 |
| Above: Thicknesser |
Finally I then stacked it using stickers to allow air to circulate around all the faces of the wood.
No comments:
Post a Comment
If you would like to leave any feedback about this post or blog, please fill out this section.