A few things have happened over the last couple of weeks.
I have started to get the wheels turned from the blanks, 3D printed a case for the control unit, and also went on a great tour of the facilities of UniPart Rail!
Wheel clamped in the center lathe with the profile started.
Showing the wheel out of the lathe and how it is still over sized.
Filling the hole that was drilled to take the front hook
A 3d printed case which has been designed to house all the speed control electronics
The first poster in UniPart Rail describing all that they construct and repair
Inside a points control unit
A finished crossing warning light ready to ship
Overhead power unit that is used on the EuroTunnel crossing
No comments:
Post a Comment
If you would like to leave any feedback about this post or blog, please fill out this section.