As mentioned in the previous post, I have now cut the axles, driveshaft and buffer beams. I also faced the axles of on the centre lathe ready to be turned down to meet the wheel bore and bearing.
To cut the buffer beams I used a metal bandsaw, and used a file to remove any burs.
The other thing that was made is the angle brackets for each corner of the angle bar.
To cut the buffer beams I used a metal bandsaw, and used a file to remove any burs.
The other thing that was made is the angle brackets for each corner of the angle bar.
No comments:
Post a Comment
If you would like to leave any feedback about this post or blog, please fill out this section.